PLEASE! I need help with my Ender 3.

[Madda]

I set it at 10 and it seemed like it got further before the plastic had enough of the nozzles work and wanted to leave the bed (I suspect that the plastic keept rising and started getting contact with the nozzle).

When printing it seems like it makes a small line and then hurls the rest into a hill and start all over from there.
[Like this __o__o__o__o__o__o]
I have no ide why. Do i need to increase the flow? Is the fan cooling it too fast?
Flow 100.
Fan speed 100%. Regular/Maximum fan speed threshold 10s.

Also goo buts that new. (Haven't goten this far)

20181224_075339.jpg20181224_075404.jpg20181224_075441.jpg

[Roberts_Clif]

I have no ide why. Do i need to increase the flow? Is the fan cooling it too fast?
Flow 100.
Fan speed 100%. Regular/Maximum fan speed threshold 10s.

How are your prints working now.

I see that your fan is running 100%.
I have never have a parts cooling fan running more than about 50%.

[Madda]

Thanks for wanting to help me.

I tried to put in your profile but cura could not open it "Hictop 1.75 Profiles 30". I tried https://www.youtube.com/watch?v=KD7MigGaKFw but got thies result.

20190126_124002.jpg20190126_124012.jpg20190126_124930.jpg
I dont know if its normal but the nozzle went outside the print by 1in (2cm) and printed above making rings in the air what it looked like. I dont know if its ignoring layers, it's the worng layer size or not enough PLA comming through