Printing rough after Titan-Aero upgrade

[curious aardvark]

for direct drive you probably need 2-3mm and retraction speed as fast as you can get away with. I usually run at 60-70mm/s
1mm just isn't going to make any real difference.

Also measure the extruded filament, looks like over extrusion.
Have you changed the firmware at all ?

looking at the gray bowl - curious as to why you bothered changing anything ?

[traxon]

Ok, I can try increasing the retraction a bit - I'll try 2mm - and I'll try 70mm/s retraction speed. I had measured exactly 100mm when I extruded 100mm, but let me run through that again to make sure something didn't change - if so, that could explain a lot. Oh, just thought of one thing I didn't try - tightening the tension on the filament - it doesn't really look like it's slipping to me, but knows.
Yep, I changed from the stock firmware to TH3D Unified Firmware. I have the same firmware on my bigger CR-10 and it works fine (that one is still bowden).
The gray bowl I printed before the titan-aero, and I used pretty much the same settings on the red prints (with titan aero), but I reduced the retraction that's all. Thanks.