Thanks for the replay. I measured the distance between the gantry and bed (39.5mm), then raised it 50mm and re-measured (89.5mm), so I guess my Z-steps are ok. I attached a few pics above (partial benchy), which should give you a better idea.


If you look at the bottom layer, it doesn't really look overextruded to me? Looks like it was lifting off the bed at the corners a bit. The whole thing is kind of warped. My nozzle temp was only 210 (supposedly - new heater and new thermister, so who knows). Bed temp was only 65 F (through the glass bed, so more like 57 F according to my pyrometer. Not that hot. I could try turning each one down I guess and see what happens, but not sure what else to try. This isn't especially good quality filament, but I've been printing with it just fine. I did run a PID tune. The bed (keenovo) fluxuates up and down between 64-66 or so on the display, which seems fine.