worked out how to get the bed temp run at 60.
you set it at 50 so the print can start, then once it's started use the front control panel to up the temp to 60.
Works.
If I set the temp in the slicer at 60 - it never gets close.
weird. But works.
Mind you my workshop was positively tropical yesterday, hit 17C !

Printed an item out last night that was 95mm long and about 40 wide.
Theoretically I've got another 7.5 mm each end - but I reckon it'll struggle with anything over 100.
That said, it worked pretty well.
Though it does struggle a little at the extremes.

Haven't yet tried to print anything of any real height. the bowden tube just looks too long, fairly sure that will caues issues at height.
we'll see.
Think I'm going to switch out the nozzle today for a 0.25mm copper one.