Newb conceding defeat and in need of help ender 3

[RobertR728]

I'm on my way to the touch screen
The noise doesn't bother me right now because it's so new, that will change I'm sure.

I was browsing Thingiverse earlier today on my phone. I'll bet i had 50 tabs open lol


^^^^^^^^^^^^
Dese guys up there know their stuff I am so glad to have found the help i have on this forum. After going over ever nut and bolt and my Z axis was way too tight. With no mods except proper adjusting of all 3 axis and the bed. I have never been so impressed by a little hollow cube in my life. Oh and what a lucky guess on filament length. This was the end of the cube lol
Its a little rough but on a moving dining room table and for some first prints i am getting a little better
Thank you for all your help
Robert <3

I think i might have just shed a tear