Hi - I just got my powerspec ulta 2.0 dual extruder a few days ago and seem to have a issue. My bed temp is lowered to 50C and my filaments (Inland PLA+ (205C) and PVA (190C) for supports) are at the low ends of the temperature range. Everything runs up fine and my print starts forming - only to see that both nozzles are oozing as though the filaments are still too hot and killing the print in the process as the nozzles move across the model. Other than slow the speed of my motor down (currently at 40mm), increase the length of retraction for the filaments (currently at 2.7mm) and increase the retraction speed (currently at 40mm), would there be anything else that I need to look at to succeed in creating my print?

I appreciate any advice.