Monoprice Mini Delta Review

[curious aardvark]

Just changed the nozzle from 0.4 stock to a copper 0.25 one.
Actual measured extruded is 0.26 !

here's a diagram to illustrate how much smaller it is. The big circle is 0.4 and the cutout is 0.25:

0-25in0-4.png

Currently having a go at a half size chinese balls model I did. So far haven't managed to print the full size one, so this will be interesting.

currently looks like this:

0.25 balls.jpg

Given that I've totally guessed the settings - not looking too bad.
If this works, I'll go down to half the size again.
well I'll do that anyway :-)
Actually the next one will be a mere 10mm with three shells. That will be interesting - looks good in the slicer :-)
The current one is 33mm

I actually also have a stainless steel nozzle at 0.15. But that's probably a 10th of a mm too far.
I'm currently using crap 6 year old esun filament. So that's not ideal. Once I've got it working really well with that I'll try it with some decent filament :-)

I dropped the retraction speed and distance and other than telling it the new nozzle size and measured width - haven't changed anything else.