Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 11-25-2018, 10:37 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    The model appears to be under extruded.

    Here is one I printed.

    3mm - 1.75mm.jpg

    What I determined was I had mistakenly set Cura Slicer to a filament diameter of 3mm in and should have been set to 1.75mm
    This caused my Under Extrusion.

    I have had the Throat tube Teflon tube deform causing the same filament under extrusion Shown below.

    Nozzle & Throat.jpg

    These Brass nozzles are plugged with the deformed Teflon tubing. There should be nothing but a brass nozzle.
    Last edited by Roberts_Clif; 11-27-2018 at 11:13 AM.
    Reply With Quote Reply With Quote
  2. 11-25-2018, 10:55 AM #2
    OvergrownDwarf
    OvergrownDwarf is offline
    Student
    Join Date
    Nov 2018
    Posts
    4
    Hi,
    Thanks for the reply, I have checked my cura settings and my material diameter is set to 1.7mm and the nozzle size is 0.3mm.
    So I don't think this is the issue.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules