Results 1 to 10 of 19
Thread: WTF is wrong with my printer???
Hybrid View
-
11-26-2018, 06:00 AM #1
- Join Date
- Nov 2018
- Posts
- 9
I cleaned the first nozzle then when it didn't help, I switched it with a new one, which also didn't work.
I used a thingiverse that worked before. I also tried an online slicer (astroprint) and Cura. they all gave me the same result.
i also thought it might be a Z axis problem so I undid the bolts holding it a little...then I tried tightening them and there's not much difference in either case.
A friend suggested that the stepper drivers might be partially blown and that I should switch the Z one with one of the other two. However I have an Ender 3 and the drivers are attached to the board.
Maybe it's just a current problem on the motor drivers, I honestly have no good idea as to what it could be.
What are my options?
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials