So for the last couple weeks I have been having issues getting Black ABS to stick. It starts out fine, then after about 20 layers the front starts to lift. Weird that it is always the front.... I created a makeshift front panel to try to help but no changes with that. I haven't covered the top yet but plan to sometime. Anyway I haven't used any PLA yet so loaded some up. I taped up a piece of glass and clamped it to the bed. To start with I just used default Makerware PLA on the highest quality setting. It actually printed just fine, no heated bed, just Blue tape. Anyway the new extreme is I couldn't get the piece un stuck from the tape. Wow, wish I had that problem with the ABS. Finally after running a razor blade under a corner I was able to use my George Forman grill scraper to peel it up. Yes, the George Foreman scraper works pretty good.

I guess next up is to use some melted ABS and try to get the Black ABS to stick again.