I now there has been a lot of discussion around what types of tricks people use for getting their prints to stick to their print beds. This is a trick that I found on reddit, that really does work extremely well.


  • heat the bed to temperature, ~110-115C
  • put a single, good coat of glue stick over the bed
  • let the glue dry
  • let the bed cool
  • Use a razor blade and scrape of the dry glue
  • Use a paper towel with rubbing alcohol to remove the remaining stuck glue.
You will definitely need the razor blade in order ot get the glue off. Has anyone else used this method?