Illinois Teacher Pits students Against Each Other With 3D Printed CO2 Car Races

[Yancy]

Loving it! I would have guessed that the red/black car would have won the race just from that photo above. Love the fact that students get to have fun in school, and it isn't at the expense of educational integrity. This guy deserves teacher of the year

[corben33]

Thanks! It was a lot of fun to do, and it something that I plan on doing again this year.

[galledw]

Corben,

Well done! I teach middle school science and have 3 3D printers. I would LOVE to get this started in my curriculum. I am writing a grant for the CO2 car materials. If you have any advice on what to buy and what to leave out, etc, I would be grateful. I assume I need a launch system, axles, wheels, and cartridges. We can design and print the bodies. Any advice? Thanks again!!

Ed

[corben33]

Ed,

That's very exciting that you are planning on putting this into your curriculum!

I use Midwest Technology Products to order all of my CO2 car accessories. Here is a link: http://www.midwesttechnology.com/cat...-%26-Supplies/

I recommend buying in bulk if you can. You should start will axles, wheels, screw eyes, washers, and CO2 cartridges.

As for the launcher, that is going to depend on your budget. This is the one I have: http://www.midwesttechnology.com/pro...0--731054.html

It is simple to assemble and easy to use. If you want to get a little fancy, I recommend PITSCO. Here is a link: http://www.pitsco.com/Technology/Dra...G3_Race_System


One final tip. If you order from Midwest Technology, always request a quote instead of going with their prices online. Their quotes are always 10%-15% cheaper. I always deal with Sarah Cruz. Here is here email: scruz@midwesttechnology.com

Hope this helps!