Ok so now the extruder that unloaded has now stopped unloading and wont take the PLA through but "clicks" all the time. I've tried some force, put the temp up to 245 as suggested and tbh, I'm way too new to take this thing apart after the 1st week. Are all printers this hard to use at the start? It seems like a lot of money on something to have worked for 5 minutes and I am/was prepared to fiddle around to get things working as i know these things are DIY but I just thoght I'd get more use out of it before I had to take the thing apart. Is this a normal printer or have I bought one with issues do you think?

Thanks guys