Quote Originally Posted by Nahoj View Post
@Martin:
Have you been at the Form1 userforum? The Form1 uses similar galvos, and Formlabs have had a lot of trubble with them. The printers start out printing really high resolution, but degrade after a while... Some users have had their printers replaced 3 times......

Johan
No I havent.... I have to admit that I would be kinda pissed off, if I payed almost 3000Euro for a printer and they used 100euro galvo's as the key component in them.
but I can see myself building a printer along the principles close to the peachy, but with 100 pound galvos - spending a total of 150 to 200 pounds for a printer. and then maybe living with sometimes needing to replace a galvo. For 3000 I would expect a higher quality overall......

Cheers
Martin