Results 1 to 5 of 5
Thread: Supports not sticking to bed
Hybrid View
-
11-12-2018, 06:53 AM #1
dimafix - best rub on print 'surface' I've tried.
Even the small bits will stick well and release fairly easily.
never had much luck with kapton tape.
A rim on the supports is also a good idea.
-
11-12-2018, 07:40 AM #2
- Join Date
- May 2018
- Posts
- 565
The tape take a bit of work to get it on correctly.. Also A jig to hold the glass bed and tape roll at a perfect 90 so you can water slide it up tight against the previous piece. The stuff MakerGear sells really works great. Just have to maintain it as EPA will pull it off when you remove the part if not careful. Recently I have taken to just applying 2 small 4" long pieces in the center of the bed. https://www.makergear.com/collection...ucts/polyimide
There are videos online that show how to water slide the tape in place
Please explain to me how to...
Today, 07:24 AM in 3D Printer Parts, Filament & Materials