Results 1 to 1 of 1
Thread: leveling the bed with a paper
-
11-10-2018, 02:27 PM #1
- Join Date
- Nov 2018
- Posts
- 1
leveling the bed with a paper
Hello!
I have an Ender 3 and have a hard time leveling the bed. The problem is that I have to go with the nozzle very far down to the bed that I have a hard time getting a thin paper between bed and nozzle. But only then I get a good first layer where the lines stick together.
Since this is my first 3D printer I don't know if this is normal but I doubt it. I have seen calibration videos where people can easily fit a paper under the nozzle or even use a business card for this. I would say my nozzle is even touching the bed already. If I've, however, a small gap between nozzle and bed my lines are separate.
Is it possible that the nozzle is damaged so there is not enough filament coming out or can there be a another reason for this?
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials