Results 1 to 6 of 6
Hybrid View
-
11-04-2018, 02:21 PM #1
- Join Date
- Nov 2018
- Posts
- 3
it seems that my printer only does weird move while printing with the sd card. I've printed three parts from my computer and it has not had any problems. ill try making covers like you did but non of my electronics are getting hot. i have two mosfets for the extruder and heated bed so the main board doesn't have a lot of stress on it.
-
11-05-2018, 08:54 AM #2
I see you have determined that the SD card is the main cause of your problems.
Rarely ever printed from the USB Computer interface could not verify that it was only a SD Card issue.
But thinking about it believe that was the case for myself.
My problem was most times I would plug the 3D Printer to my Computer and it would reboot.
In Short the 3D Printer would short out my computer. Have always printed from a SD Card.
In fact still print from the SD Card on the 3D Printer, using the Pi's mainly to Stream video and preform minor tasks
Adjusting Bed and hot end temperatures
Preheat hot-end and Heat-Bed
Emergency Stop
Purchased Many Raspberry Pi's for different uses.Last edited by Roberts_Clif; 11-05-2018 at 10:24 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion