Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 12

Threaded View

  1. 10-21-2018, 05:35 PM #4
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    I started with it's predecessor, It has two 8mm smooth rods to support the hotbed, It also has a large build area 220mm X 270mm X 190mm.

    On the Hictops 3D Printer page it is the same price as the Ender 3 at $269.00. The only part I would Purchase would be a Proximity Sensor SN04-N to replace the Z-Axis end-stop switch.
    I have all the Marlin Firmware configured up to Marlin 1.1.9, however I stopped flashing my 3D Printers at Marlin 1.1.5 though continued to update the firmware as it came out for others.
    Last edited by Roberts_Clif; 10-21-2018 at 06:54 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules