Results 1 to 3 of 3
-
10-08-2018, 01:11 PM #1
- Join Date
- Sep 2018
- Posts
- 5
New Ender 3 printing problem - Brittle prints
I just got a Ender 3 as a replacement to my old I3 prusa. When i print the included test print (a dog) it prints really well. however, when i print a .stl that prints fine on my old printer, it prints very brittle. i can cross see sections of the extruded filament when i hold the print to the light.
I think its the Cura settings. The original software that came with the printer is Cura 3.4 and the settings were included but i am using the newest version of Cura, 3.5 which have the ender 3 settings preloaded.
I have done research and it seems like the likely answer is increase flow rate. I was wondering if there is any other recommendation.Last edited by merc718; 10-08-2018 at 01:16 PM.
-
10-08-2018, 02:55 PM #2
- Join Date
- Sep 2018
- Posts
- 5
Well, i just ended up using the supplied software and settings. it works fine. I have to try to fiure out how to transfer those settings to the newer version.
-
10-10-2018, 05:02 AM #3
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help