Fair bit of progress

Got top mounted filament holder - works but still needs to be a little more rigid.
Picked up a sticky print surface at tct. Not sure what it is but it's good stuff.

Bed levelled like a dream. Aluminium plate appears to be really flat.

First three things I printed were trolley keys.
Did the first one at 50mm/s - 2nd at 100mm/s and the third at 150mm/s. 0.32 layer height.

All three are dimensionally accurate and I can't tell which was printed at which speed.
Very impressed.

Also did a 190x190mm square frame. Useful to have but also great to check edge bed levellness.
Again went perfectly.

So that's all good.
On the negative side I don't think the micro sd card reader works.
It appears springy but the card won't click in :-(
I do have a basic screen with sd reader attached - so might try that at some point.

Very impressed with how fst it can print. particularly given the un-sprung extruder.