How good is a sub ?100 3d printer ?

[curious aardvark]

final step settings were: X82 Y80

Every time I ttempted to change the Z axis settings everything went terrible. But as it seems to be spot on anyway - not an issue :-)

So I've just started my first serious print. A 2 part mould that will take over 4 hours.
Running from the sdcard.
Sizing is very important for these, so it'll either be a success or a waste of 120gms of pla :-)
Running slightly faster than I run the same thing on the delta - but as the delta has an 0.5mm nozzle and this one the bog-standard 0.4 - about the same length print.

Which is still pretty impressive :-)

It's also pretty quiet.
Doesn't sing like the delta and rep clones do, kind of a shame, I like the R2D2 noises.

Could that be down to the stepper driver ?
No clue what this is using - cheap ones I would imagine.