Printing: Damn corners..

[DrLuigi]

Did you solve this?

on my machine with preloaded firmware the accelleration was set to 500 mm/s which caused some ugly corners like yours, i set my

DEFAULT_MAX_ACCELERATION to {1500,1500,5,1500}
DEFAULT_ACCELERATION 1000
DEFAULT_RETRACT_ACCELERATION 1000

and

#define DEFAULT_XYJERK 20.0 // (mm/sec)
#define DEFAULT_ZJERK 0.4 // (mm/sec)
#define DEFAULT_EJERK 5.0 // (mm/sec)


this helped a lot, as the machine takes the corner at higher speed, i then get less ooze from the machine slowing down.

Since i still got this problem with the corners i gonna try this now,
I normaly lowered my acceleration and jerk by half (in my case it was 1000, changed it to 500)
Since i had some skipping, this resolved it, i think.

Gonna try your solution now and see if the corners are any better, my print speed is in this case 50mm/s wich isnt that fast at all,

I still remember when i just had my printer my corners were alot better, aka before i changed acceleration, So ye it might be that!


Edit:

Meh still the same : https://www.dropbox.com/s/plsgjxpp9b...2022.33.19.jpg

No idea how to fix it after that..