Results 1 to 10 of 23
Threaded View
-
08-01-2018, 09:58 AM #8
- Join Date
- May 2018
- Posts
- 566
Did this round but figured would be a waste of plastic so trimmed it.Hole in center is 40mm diameter is 74.55 and width is 60mm Let me know what needs to change if anything. Not sure how it will land on the printer bed, but adjust in slicer so it is flat on bed..If once printed it is too loose in the spool of filament, wrap some duct tape around it to get a tight fit rather than reprinting it.
Last edited by airscapes; 08-01-2018 at 10:09 AM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials