OK lets try this. It appears that the PLA is firmly adhered to the bed when the temperature is 200C, though the corners of the parts seem to grow.
(Could be because the over-temp is causing oozing filament sticking during the corners. When I drop the temperature this oozing stops.)
(This could be partly caused by Z_Hop that is allowing the filament to grow at these locations.)

When the Temperature is 196-198C on 3DP11 (Measured using a DVM digital temperature probe) Parts print smoothly.
Next Print I will print at 202C with a bed temp of 56C to See what happens.

MakerBot | Colours Engineer Drawing Art US |"10 rolls" Label in side below
- Temperature 190-210C
- Base Plate 30-50C

ZYLTech - 2 Rolls
Label in side below
- Temperature 190-220C

WYZworks 10 rolls
- Print Temperature Range: 180 - 220C

ZYLTech 2 Rolls
Label in side below
- Temperature 190-230C