Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Threaded View

  1. 06-23-2018, 06:59 PM #3
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Hello

    I have two of these HICTOP Prusa I3 DIY I have upgraded them to the max.

    The Twins 2018-2.jpg

    And have 3D Printed all the white, blue and red parts you can see.
    I even added T-Slot Led light strips covers.

    It does go a little beyond your budget.
    Before you jump into buying any 3D Printer scan the forum and you-tube for 3D Printer videos you can see videos good and bad about almost every 3D Printer.

    Beware they have 3D Printers made so cheap the frames break during assembly.
    Last edited by Roberts_Clif; 07-12-2018 at 05:45 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules