Close



Results 1 to 10 of 13

Hybrid View

  1. #1
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,154
    Add Roberts_Clif on Thingiverse
    Quote Originally Posted by Kyle M. View Post
    I'm getting closer but I'm still not there. I'm currently at 220 nozzle (Inland recommends 215-225) 60 bed and 40% fan. Trying to print a calicat as the first one I did when I got the printer came out perfect. I'm getting a lot of uneven spots on the overhanging parts of the tail. No matter what I do if I go over 50% fan I get total failure. Less than 215 requires 35% fan or lower.
    Is it possible that the fan is somehow shorting to another wire some how causing the problems.

  2. #2
    Quote Originally Posted by Roberts_Clif View Post
    Is it possible that the fan is somehow shorting to another wire some how causing the problems.
    I suppose it's possible.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •