Results 1 to 10 of 13
Thread: Anet A8 fan/extruder issue.
Threaded View
-
05-06-2018, 03:50 PM #3
I have never used the Fan at 100% the maximum is about 50%.
Using a half Circle duct around the Nozzle,
TL-W3M 3.jpg
I have designed a duct port to cool the throat using only Half of the Heat sink Below.
Image3.jpg
I wonder if the fan is not adding more noise to the circuit causing the failure.
Try using 50% to see if that helps.
Does your printer have a restore to factory. On my 3D Printers need to Restore Factory Defaults when it acts goofy.
(This happens when I try different Slicers and they mess with my Defaults.)
M502 ; Restore Factory Defaults
M500 ; Store Settings.
Please explain to me how to...
Today, 12:15 PM in 3D Printer Parts, Filament & Materials