Results 1 to 6 of 6
Threaded View
-
04-15-2018, 09:11 PM #2
More information may be needed. Sounds like the X-Axis is working, Have you checked to see that the Y-Axis end-stop in not defective, and correctly wired and positioned for the switch to work.
Was the Marlin 1.1.2 firmware pre-configured, or did you configure it your self. If you configured Marlin 1.1.2 you could post it your configuration.h file for verification.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help