Results 1 to 2 of 2
  1. #1

    Unhappy X-Rods not glued? Possible defect?

    I needed to replace several parts of my printer, including the fan, so I was reading the Fan Replacement guide here:

    And the very first line caught my eye: "One side of the X Rods will be glued to the sliders, one side will not."

    Wait, is one side of these these supposed to be glued? Because mine never were, and I always wondered if that was normal, because the rods actually slightly move due to the gap from not being held down in any way whenever the printer calibrates it's x/y axis before a print.

    Does anyone here have X-Axis that are glued down? If so, which side? And would it be a good idea to glue mine then to avoid issues/inaccuracies? I think the rods might slightly be moving during movements/homing because they are not glued down.

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    not a clue, maybe ask the micro3d people ?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts