Results 1 to 5 of 5
Threaded View
-
06-15-2018, 05:49 PM #3
Hey Roxy,
I downloaded Marlin 2.0 again recently to see if UBL had improved and unfortunately I was unable to replicate my success with G33 auto calibration. It homes, travels down to the bed at a fast speed (never hits the probe speed I set) and then just stops with a motor hum. If I manually toggle my Z probe it jumps to the next probe point, but it does not seem to want to probe on it's own.
If I increase my Z height it simply slams into the bed without ever toggling the probe.
I will upload my config.h once I get home.
Please explain to me how to...
Yesterday, 02:43 PM in 3D Printer Parts, Filament & Materials