Results 11 to 20 of 31
Thread: Kossel Mini Build (750/360)
Hybrid View
-
05-12-2014, 08:42 AM #1
-
05-18-2014, 04:59 PM #2
- Join Date
- May 2014
- Posts
- 100
Any suggestions on how I should cover up the bare extrusions on my delta? I want it to have a clean-sleek look. MDF? Metal Panels? thanks.
-
05-23-2014, 04:15 PM #3
-
06-17-2014, 05:38 PM #4
- Join Date
- May 2014
- Posts
- 100
Finally got my NEMA 17 motors. Will be finishing up assembly in the coming days.
-
05-18-2014, 09:48 PM #5
Metal plate if you're able to powder paint it. Else, I would do MDF with glossy paint!
-
05-18-2014, 11:54 PM #6
- Join Date
- May 2014
- Posts
- 100
Any idea on how to attach it to the extrusions? I am thinking about just using M3 screws, but I hear MDF doesn't take well to screws.
-
05-21-2014, 07:39 PM #7
if you use MDF, make sure the MDF hold my the head of the screw, it should work like this!
-
06-23-2014, 12:22 AM #8
- Join Date
- May 2014
- Posts
- 100
Finally soldered 3 motors and temporarily set up an atx power supply to run with it. However, I am running into issues. When I decrease the Z-axis control on Repetier, the Z-motor does not rotate, however when I increase the z-value, it does rotate. Any ideas?
-
06-25-2014, 09:03 AM #9
Is the motor moving both way if you using RAMP test ?
If yes... I dont know... it's software related, but I dont really know the software yet. You're using a "delta" configuration right?
If no...
- Did you ajust the "power" screw ?
- Make sure all the cabling is good. Maybe you didnt connect "Enable A/B" or power is not working.
-
06-25-2014, 11:53 AM #10
- Join Date
- May 2014
- Posts
- 100
Actually I figured it out, I had autoprobe in the firmware on, but had no endstop in the autoprobe pins, so when I checked M119, it showed Z_min as always high and thus Z would never decrease in value. It is fixed now though Thanks.
However, I am having issue wiring up my Geared Stepper Motor from Kysan. I purchased it from Tridprinting. The schematic is located here: http://www.tridprinting.com/Electron...perMotor-1.pdf
The plug I received are reversed though. I am unsure on how to wire it to my RAMPS board.
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials