Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 31

Hybrid View

  1. 06-28-2014, 05:36 PM #1
    JohnA136
    JohnA136 is offline
    Super Moderator JohnA136's Avatar
    Join Date
    Oct 2013
    Location
    Jersey Shore
    Posts
    548
    I think there is a setting in Repetier to not allow the extruder to turn until it is 170 degrees. I use by LCD panel to turn the extruder motor on my Kossel Mini.
    Reply With Quote Reply With Quote
  2. 06-30-2014, 02:26 PM #2
    MK-X
    MK-X is offline
    Technologist
    Join Date
    May 2014
    Posts
    100
    Yeah I was able to get it to work by turning the minimum extrusion temp as well as the minimal defect temp below -10 degrees. I didn't have my hot end thermistor plugged in so the defect temp showed -58C. Now I am trying to wire up 615rakabMOL._SL1500_.jpg to my dedicated power supply. Any ideas?

    Mechanically its up and running, but the belts aren't too tight.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules