Tried to print with slower speed, 60%, did not solve the problem. Tried to turn off retractions in the settings, did not work.

Quote Originally Posted by Roberts_Clif View Post
I was using different Slicers, Getting to know them and somehow it placed a 3.00 filament size into the printers defaults. Every time I rebooted it thought filament was 3.00mm.

Resting to firmware defaults restores the firmware's settings.

Do no know if this is your problem, was just putting out information I had experienced..
I see, thanks for the info I don't think that is what happened here though, but you never know... will keep investigating.