Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 10-21-2017, 07:25 AM #4
    raylo32
    raylo32 is offline
    Technician
    Join Date
    Aug 2017
    Posts
    95
    Just a tip for other folks with this printer... I am trying something to ease the stress on the x-axis cables, both of which have failed on my 3 month old machine. The last top cable clamp towards the rear is the problem, IMO. It creates a severe angle and the cables repeatedly bend sharply in the same spot. So I dressed the cables leaving that clamp off. Now the cables furl and unfurl over a larger radius instead of bending in one spot. We'll see how this goes.

    Red circle in photo shows the case stud for the cable clamp I left off.
    Attached Images Attached Images
    Last edited by raylo32; 10-21-2017 at 09:06 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules