I need a little gcode help for a start routine

[Roxy]

I need to adjust the z offset of the start routine. My first layer has some gaps, but all others are perfectly fine.

You can use G92 to set the current coordinate values. For example... After the machine goes to Z=15.0mm you could do a G92 Z15.25 to move the nozzle closer to the bed.

[Irkie500]

You can use G92 to set the current coordinate values. For example... After the machine goes to Z=15.0mm you could do a G92 Z15.25 to move the nozzle closer to the bed.

Thank you! thats exactly what I was looking for. I tried every variation of Z Offset setting in google to try and find something and came up dry.

When I get home I will copy and paste my current start sequence just to make sure I have this correct.