Results 1 to 2 of 2
Threaded View
-
08-24-2017, 02:24 PM #2
- Join Date
- Aug 2017
- Location
- Sweden
- Posts
- 2
Lo and behold after 9!!!!! hours of no go, it works.
A managed to get it to accept the firmware.
After reading this.
"As RepG does a few retries before it timed out again in the log, I just pressed the reset button with a pen tip and it started flashing."
I thought , hey i try to press the resetbutton every 2 sec until the green light start flickering.
So i pressed download, pressed reset,1, 2, 3,4 ,5 , 6 times and then it started to comunicate.
Now i have 2 lines in the LCD and the heatbed is warming up , as expected.
Best regards, Hasse.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials