Results 1 to 10 of 12
Thread: Einscan software update 2.5
Hybrid View
-
08-13-2017, 02:55 AM #1
- Join Date
- Aug 2015
- Posts
- 241
That doesn't look that great, did you have to run a calibration before using the new software ?
I am always very hesitant to update software that already works great, especially on Win, where I'm no so familiar with
-
08-13-2017, 03:18 AM #2
- Join Date
- Jul 2014
- Location
- UK
- Posts
- 124
Yeah, you always have to calibrate when you install a new version as you have to uninstall the previous version.
One thing I noticed was the alignment was a bit off so I might try calibrating again to see if I can get better alignment.
I can't really see too many new features in this version so if the scan quality doesn't improve I'll be going bck to 2.3.
-
08-13-2017, 11:27 AM #3
- Join Date
- Jul 2014
- Location
- UK
- Posts
- 124
Well, much to my embarrassment, I've just realised I made a big cock-up with my first test of this new version.
The picture I earlier, which was lower quality, was in fact a 3d print of the original injection molded model which I scanned then printed, doh !
So the scan quality was always going to be worse with the printed model.
Please ignore my post (which I've deleted) about the quality of v2.5 until I've tested it further and apologies for any confusion.Last edited by scobo; 08-13-2017 at 11:38 AM.
-
08-13-2017, 01:52 PM #4
- Join Date
- Jul 2014
- Location
- UK
- Posts
- 124
Ok, after scanning another couple of objects, I'm happy that the quality is at least as good as previous versions and 2.5 seems to be working fine.
Still haven't noticed a great deal of difference to 2.3.3 though.
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials