Results 1 to 9 of 9
Hybrid View
-
08-12-2017, 02:13 PM #1
ah that video makes me all nostalgic for the days I had to fight the prints. Don't know how you guys can keep on doing it ;-)
-
08-12-2017, 08:41 PM #2
Actually that print was way too close to the bed, I was showing how secure you could get your prints on Vinyl Transfer Paper.
When adjusted up a little higher the prints come off with a couple light taps, and a little bit higher again you can slide the putty knife right under the print without damage to the paper.
After 3 or 4 prints in the same location you may need to buff with a 1500G sand paper to get good adhesion again.
I tested the Vinyl transfer paper it too stuck much better if applied when warm.Last edited by Roberts_Clif; 08-13-2017 at 09:29 AM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials