Quote Originally Posted by curious aardvark View Post
when you say 'emboss' you don't mean what I mean, when i say 'emboss'.

But it sounds like fun, I'll give it a go. You using 6mm tubes ?
Or 7mm - been a while since I've made one.
Sorry about the embossing term. Perhaps I'm using the wrong term. I mean to cover it in a clear polyester casting resign.
Thanks for giving this a go mate. The particular pen I was going to do this on is a 2 chambered pen. Here are the specs on each part.

Skull Pen- (the one I was going to make "The Punisher" on)

UPPER BARREL- To have the moon design with a slight shadow of the punishers logo on it slightly covered in clouds
3/8" - Diameter Tube
1.36" - Length
Design Cannot be thicker than .575" (.475" to be safe) So that when I "turn" the resin on the lathe it doesn't eat into the design......And hopefully it doesn't have a catastrophic failure lol!

LOWER BARREL - "The Punisher".....flames in background with his guns....or some awesome Punisher pose or whatever
3/8" - Diameter Tube
1.710" Length
Cannot be thicker than .575" (Same as above) lets say .475" to be safe

OR If you want to test it out on something easier for now there's this pheonix pen style that has one chamber tube
Tube Specs
5/8" Diemeter
2.67" Length
.550" bushing sizes (so don't make the design thicker than .450")

Maybe put a phoenix rising from the flames or something?