Auto_Bed_Leveling: Enhanced G29 command

[adamfilip]

where can we get the version of Marlin with the Mesh leveling feature?

[adamfilip]

Great, I really hope this helps making ABL more reliable thank you for your contribution to marlin

[adamfilip]

I see some mesh levelling code in marlin.
its labeled under manual bed levelling

Can you advise how to enable Mesh Auto bed levelling

[Roxy]

I see some mesh levelling code in marlin.
its labeled under manual bed levelling

Can you advise how to enable Mesh Auto bed levelling

I have not looked at it yet. But the 'manual' part of it is a negative. I'm thinking this can be fully automated.

[epatel]

I don't have any servo etc mounted on my machines so hard for me to add. But another developer is looking at making it fully automatic

[Roxy]

I don't have any servo etc mounted on my machines so hard for me to add. But another developer is looking at making it fully automatic

Certainly no disrespect was intended by saying 'not automatic is a negative' ! It takes time and many steps to get good software! It would be nice if we could have 20 or 30 areas defined on the bed. But to probe that much is not going to be pleasant so that would have to be something saved in the EEPROM. And then my other hope is I get full control over how many layers before the mesh firmware backs off and is out of the picture.

[epatel]

It has been merged and is now part of the Development branch. I have also added this short description https://github.com/MarlinFirmware/Ma...BedLeveling.md

[inventabuild]

It has been merged and is now part of the Development branch. I have also added this short description https://github.com/MarlinFirmware/Ma...BedLeveling.md

I own a TAZ 4 and the X-axis dips at least 0.15mm in the center of the bed due to the weight of the dual extruder.

Can I use the mesh mapping version of the bed leveling code that you created to account for this 0.15mm dip?

I don't have a bed leveling probe, but I would like to manually enter height values for the 4 corners of the bed plus three points along the X-axis (two opposing edges + the center of the bed). Is this possible with your upgrade? Will your upgrade create a concave up map of my TAZ 4 bed?

[applekeith]

Does anyone else have an issue trying to download? I cannot get either file... seems to be redirected to clear.gif.
Alternatively, is there a build out there with this implemented?

[Roxy]

Does anyone else have an issue trying to download? I cannot get either file... seems to be redirected to clear.gif.
Alternatively, is there a build out there with this implemented?

Probably, the right thing to do is go here and use this code base. All of the good stuff is in it and it is stable and works. (Which is more than we can say right now about what is at GitHub/Marlin) !

https://github.com/beckdac/Marlin

If you have a MakerFarm printer, you just load and go. If you don't have a MakerFarm printer, cross your Configuration.h settings over to its Configuration.h file. You should be up and running in very little time.