Did you do an M114 in repetier and see where it thinks the machine is.
Make sure the bed size is correct and the home position too.






Quote Originally Posted by Deividmaxx View Post
I still do not get repetier show me the values that appear on the LCD. Using the command G28, G29 and then again G28.
When It finish I get this result:

In the LCD: x: 142.0 Y: 47.0 and z: +11.8
In Repetier-Host: x:0 y:0 z:0

Log of Repetier-Host:
10:11:53.485 : Base x: 30.00 y: 30.00 z: 11.67
10:12:04.516 : Base x: 140.00 y: 30.00 z: 12.19
10:12:15.985 : Base x: 140.00 y: 140.00 z: 11.81
10:12:27.548 : Base x: 30.00 y: 140.00 z: 11.21
10:12:27.548 : Eqn coefficients: a: 0.01 b: -0.00 d: 11.61
10:12:27.548 : planeNormal x: -0.01 y: 0.00 z: 1.00

Is there any way or G code that allows me to pass the printer values to Repetier?

And another thing I do not understand is that when I ran the G29 command after the G28, the servo arm does not go down first and then the carriage moves to the position of the first measuring point.