Hi Roxy,

I have read through a pretty decent chunk of this thread. I have implemented ABL on my printer but as others, am experiencing some problems with it. I have attempted to implement the latest version of your Marlin Fork to try and get a typography report. However the grid was far too small for my bed, (450 x 450) and i was unable to change the amount of measurements taken. Are you able to shed some light on this for me? Or can i easily add your adapted ABL code into my existing version of Marlin?

If you get a chance to write back it would be greatly appreciated, i havn't had a successful print bigger than 1" squared in weeks and its killing me and motivation to get this printer setup right! Just for reference i have a home built gMax 1.5 Printer.

EDIT: I somehow managed to miss the first post of this thread (went straight to page 2?!) i will get your code into my firmware and report back.

Thanks

Alex