Results 1 to 10 of 757
Hybrid View
-
07-10-2016, 09:47 AM #1
Ok, I did the change to #define AUTO_BED_LEVELING_GRID_POINTS 5
I went to pronterface, ran G28.
when I sent G29 n 2 i got this error message:
Code:>>> g29 n 2SENDING:G29 N 2 Error:Line Number is not Last Line Number+1, Last Line: 0 [ERROR] Error:Line Number is not Last Line Number+1, Last Line: 0 Resend: 1
I'm searching for information on this error but not getting anything definite - Thanks for any ideas.
-
07-10-2016, 11:08 AM #2
Ok, I transferred all the information from configuration.h to the new one for RC6 bugfix and flashed it. I can't get it to home to the back right as my endstops are set up for (and as a lot of makerfarm I3v's are set for) previously there was a place to define the home as back right which I don't find in the new configuration.h. I saw somewhere a positive/negative homing direction setting, I will go look for that.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help