Results 1 to 3 of 3
Thread: Alignment in MakerWare 2.4.0.14
-
07-18-2017, 09:03 AM #1
Alignment in MakerWare 2.4.0.14
Makerware doesn't seem to know where the left nozzle is. I've done the nozzle alignment built into the printer where it prints a bunch of lines and you tell it which align better.
Any dual extruder part like the pendant
alignmentB.jpg
Come out misaligned
alignment.jpg
I have "MakerBot The Replicator Dual" selected for the printer.
My antique printer:
paleobot.jpg
Are there settings I don't know about, like in a file somewhere?
-
07-18-2017, 10:28 AM #2
that's not just misaligned.
Have you definitely got dual extrusion ticked in the control panel ?
Well it's printed both wipe walls. So yep.
Weird, they are no nozzle offset settings that I know of.
That is odd.
-
07-18-2017, 10:44 AM #3
I found a whole file of settings, but nothing about the relative positions of the two extruders.
Wondering if I should put sailfish on this.Last edited by Torby; 07-18-2017 at 10:52 AM.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help