Printrbot Introduces the Printrbelt

[Feign]

Jeff has a point, controlling the layer orientation of a part on this would probably require a raft tilted off the belt to be parallel to the gantry. That would end up being a very thick raft in most cases.
If I remember correctly, Steele's prototype (and from the looks of it, the Printrbelt also) have the gantry at a fixed 30^o angle from the belt.

[Ama-fessional Molder]

Jeff has a point, controlling the layer orientation of a part on this would probably require a raft tilted off the belt to be parallel to the gantry. That would end up being a very thick raft in most cases.
If I remember correctly, Steele's prototype (and from the looks of it, the Printrbelt also) have the gantry at a fixed 30^o angle from the belt.

Yes, but we already deal with that. If we want specific orientation we have to deal with a ton of supports in many cases.