3D printer MOD. Auto ejection with web based queue and server side slicing.

[mmiscool]

Been doing some more work on this project.

I am at v3 of the machine.

Switched to using a raspberry pi 0 w as the controller is stead of a netbook. The pi has a real serial interface and the chip doing the usb to serial did not really like emi in terferance with the new linear actuator I was using.

[Roberts_Clif]

Been doing some more work on this project.

I am at v3 of the machine.

Switched to using a raspberry pi 0 w as the controller is stead of a netbook. The pi has a real serial interface and the chip doing the usb to serial did not really like emi in terferance with the new linear actuator I was using.

Hello,

Like your 3D Printing system ingenious.

Like you I too had EFI problems, It started when I purchased a 2nd 3D Printer that was 24volt Hictop 3DP12.
I solved you EFI troubled by 3D Printing a case and lining it with Aluminum Duct tape and Grounding the Duct tape.

This was a simple fix you may think about as a solution for your EFI troubles, I will supply a link to the My Complete Post.


http://3dprintboard.com/showthread.p...2-EFI-Problems


Would really like to hear more about this 3D Printer you built.

I too print on a disposable print surface, though my surface is a Vinyl transfer Paper Tape used for transferring Cut Vinyl from its origin surface.
Vinyl transfer Paper Tape cost about 10cents per 1 Foot bed covering, is quit a bit more than your single sheet printer paper, though is still disposable and has a adhesive back.