Results 1 to 2 of 2
Thread: ABS print only problem
Hybrid View
-
04-23-2014, 09:28 PM #1
This has nothing to do with the fact it's ABS or PLA. This is a Gcode step that is beyond the limit of the platform - thats all.
Have you tried actually printing from your PC and not the SD card examples they give you yet?
If the left extruder is printing off the platform, it wont matter whether its PLA or ABS in there, its still going to print off the platform. Swap filament sides, you will get the same result.
The other option is your End Stops are configured incorrectly for the left hand side OR your touch switches are not being activated on the side possibly..
You wont understand Gcode most likely at at the moment, but it sounds like a bad code on your SD card, i would try printing from replicatorG and physically selecting that extruder and printing something in the middle of the plate, see what happens.
**Edit
Have you run a calibration yet?
Last edited by Geoff; 04-24-2014 at 02:21 AM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials