Hi, im also new to 3d printing. I am going to use it at home mainly for fixing things.. printing clips, tools, accesories, handles, brackets... so would like to be able to print decently tough things. is pla and abs good enough.. or should I be looking for something that can do nylon?
was looking to spend around 500$.. so was looking at maybe a Prusa mini+ but found out shipping is going to be quite high. would that printer be good quality but still beginner friendly? would I be better off looking for something based more in NA for parts and warrenty? I live in CA. also was goinig to put it in my basement.. it's spray foamed so no drafts., and would put a dehumidifier. but can get a bit cold. probabaly 9degrees C. will the cold and little bit of extra dust be bad with a non-enclosed 3d printer. (don't have much room in my house otherwise. only other place is garage.. which is colder and dirtier.)
I also have no 3d modeling exp... I started trying to learn on blender, this program not too bad to learn but can do more technical stuff down the road?
thank you for your time in advance.