Results 1 to 10 of 10
Thread: Using Cura for Pegasus printers.
Threaded View
-
02-05-2019, 08:45 PM #10
- Join Date
- Jan 2019
- Posts
- 8
Been enjoying the printer and slic3r... and then went beyond a small model. To configure for a Pegasus 10, just drop to 230 mm or so from the settings that Seattle_Phil had? I'm trying to get a prototype piece, and slic3r chugs along for about 5 minutes and crashes. Anything to add to the above discussion before trying Cura?
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help