Results 1 to 1 of 1
Thread: no Stringing, but Starting Blob
Hybrid View
-
03-29-2017, 11:34 AM #1
no Stringing, but Starting Blob
Hi guys, I'm fairly new in 3D print.
Just bought a used Kossel Delta and really happy.
It working fine and I'm learning the bases of calibration.
I got good success to get rid of Stringing with retraction settings, yeee
But I have a "starting blob" on the inclined tube, it's when the nozzle arrived to start doing its layer, not the exit.
Any advice that can prevent this "too earlier start blob" ?
Thx
income_blip.jpg
Cylinder are 20mm height
Inclined one is around 30° angled
PLA
bed 70°C
nozzle 200°C
E3D 0.40mm
layer precision 0.13mm
don't have the speed here, but it was medium, not slow, not fast.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials